Custom Cut Fit:
Built to the length and width measurements entered for a clean, seamless coaming bolster pad.16mm Foam Cushioning:
EVA/PE blend foam provides comfortable padding while fighting fish or leaning against the gunwale.No Seams or Piecing:
Custom sizing helps avoid piecing together foam sections or creating visible seams.Peel-and-Stick Installation:
Easy adhesive-backed installation requires no mounting hardware.Marine-Ready Material:
Formulated for harsh marine environments and regular onboard use.Non-absorbing Surface:
Foam is designed not to absorb water or become slippery during normal marine use.Surface Protection:
Helps protect boat surfaces in high-contact cockpit and gunwale areas.Sold Individually:
Each custom coaming bolster pad is sold as a single piece.
"Build Your Own" Custom Foam Coaming Bolster Pad
SKU
13770-80340
$0.00
Regular Price
Ships FREE on orders over $150!
Helping Boaters
since 1979
since 1979
Honest Expert
Advice
Advice
100% Satisfaction
Guarantee
Guarantee
Product Details
Tech Specs
| Material | EVA/PE blend foam |
| Thickness | 16mm |
| Sizing | Custom cut to customer-entered length and width |
| Installation | Peel-and-stick adhesive backing; no hardware required |
| Surface Properties | Non-absorbing and designed to resist slipping |
| Construction | Single custom-cut foam pad with no pieced seams |
| Surface Protection | Helps protect boat surfaces in high-contact areas |
| Quantity | Sold individually |
How to Install
Required tools:
Sharp razor blade or knife
Alcohol-based cleaner, isopropyl/rubbing alcohol
Clean rags
1-2” wide Masking Tape
Roller or squeegee
- Clean and prep the surface before installation using an alcohol-based cleaner, such as isopropyl or rubbing alcohol
- Allow the area to dry completely prior to installation
- Do a dry fit before beginning installation to determine exact placement, alignment, and orientation of each piece
- Flip the pad over and use a sharp razor blade to carefully cut a line down the middle of the paper backing, being careful not cut into the foam
- Gently peel up an inch or so of the backing on both sides of the cut you just made to expose the edge for easier removal and flip the pad back over into the exact placement you want it installed
- Secure one side of the pad to the deck or surface with masking tape to prevent shifting or movement during installation
- To begin applying, lift the un-taped side of the pad and start slowly pulling the paper backing away from the center towards the outer edge while smoothing down on the top of the pad firmly with your other hand, squeegee, or roller as you move to prevent air from being trapped underneath
- Apply pressure along all the newly applied edges with your hand, squeegee, or roller to help secure the bond
- Remove the tape and repeat the process on the side of the foam pad
Cleaning & Upkeep
Cleaning:
Clean spills and messes immediately to reduce possible staining. Some materials can stain the decking if not quickly removed. Ex: ketchup/mustard, fishhooks left to rust, fish blood, bird droppings, etc.
Clean dirt or stains with an all-purpose cleaner with water and a medium-bristle deck brush. Mix the cleaner with warm water in a bucket and dunk the brush in. Work the soapy water into the decking with the brush until the dirt comes up. Rinse with water.
To remove fish blood: Mix 1 cup of bleach with 1 gallon of warm water. Dunk the brush in the bleach water and scrub in a circular motion until the blood is removed. Repeat as needed.
Do not use mineral spirits for cleaning
For longevity after installation, it is recommended that the surfaces be covered or stored out of the sun when not in use.